How to reset maintenance interval on evolution/sync 2.0 unit

How to reset maintenance interval on evolution/sync 2.0 unit

How to Reset Maintenance Interval on Evolution/Sync 2.0 Unit

Disclaimer: Resetting the maintenance interval is a procedure that should be undertaken with caution. Regular maintenance is essential to comply with warranty requirements. Failure to adhere to maintenance schedules may result in the revocation of the unit's warranty by Generac.

  1. Ensure the unit is in the off position.
  2. Press the ESC button.
  3. Scroll up or down until you reach the Sub Menu option, then press ENTER.
  4. Scroll up or down until you find the Maint option, then press ENTER.
  5. Scroll up or down until you see Maint. Log then press ENTER.
  6. Scroll up or down until you locate Maintenance Reset then press ENTER.



    • Related Articles

    • How to Reset Mobile Link Password?

      How to Reset Mobile Link Password 1. Go to the Mobile link website: https://www.mobilelinkgen.com/ 2. Click on the Login tab at the right corner. After click on forgot login user or password and the following screen should appear. To reset your ...

    • What is the service or maintenance schedule of my air cooled generator?

      Air Cooled Generator Service/Maintenance Schedule Regular maintenance is essential for ensuring the reliable operation of your air-cooled generator. Below is a recommended service schedule: Daily Maintenance (If running Continuously) Check the ...

    • Generator Fuel Consumption by Unit Size

      Generator Fuel Consumption by Unit Size Engine Type Generator KW Fuel Comsumption at 100% Fuel Consumption at 50% Rating BTU/HR BTU/HR LP Vapor Nat Gas LP Vapor Nat Gas LP Vapor Nat Gas BTU/HR Gal/HR BTU/HR BTU/HR Gal/HR BTU/HR A/C - 3600rpm 7 6 ...

    • Air Cooled Installation diagrams and specs for connections on unit.

      Her are some diagrams of air cooled unit specs that will help you with placement of gas and electrical connections. 

    • How to Clear Emergency Stop Alarm/Fault (E2800) in Air-Cooled Units

      Why are you are getting this alarm? This error code will display on the controller screen when 1 or both of the auxiliary shut down switches is set to the off position. The switches were recently put on the units to meet code requirements in the ...